Technical Data And Drawings; Electrical Data; Transformation; Positioning - Lotus CF4-68ET Installations- Und Gebrauchsanweisungen

Mit elektrischem ofen und für grossküchen

Vorschau ausblenden

Seite von 44

/ 44
Inhalt
Inhaltsverzeichnis
Lesezeichen

Inhaltsverzeichnis

Verfügbare Sprachen

The data plate is attached to the back panel (see drawing electrical connection point) and contains all the information

necessary for connection.

DIMENSIONS

MODELS

80 x 60 x 91h

CF4-68ET

CF6–610ET

100 x 60 x 91h

CFM4-66ET

60 x 60 x 91h

CFM4–68ET

80 x 60 x 91h

CFM6-610ET

100 x 60 x 91h

60 x 60 x 91h

CFMC4-66ET

DIMENSIONS

MODELS

CF4-68ET

80 x 60 x 91h

CF6–610ET

100 x 60 x 91h

60 x 60 x 91h

CFM4-66ET

CFM4–68ET

80 x 60 x 91h

100 x 60 x 91h

CFM6-610ET

CFMC4-66ET

60 x 60 x 91h

CF4-68ET

80 x 60 x 91h

CFM4-66ET

60 x 60 x 91h

CFM4–68ET

80 x 60 x 91h

60 x 60 x 91h

CFMC4-66ET

On positioning the appliance, ensure that it is perfectly levelled. Small adjustments can be made by screwing the

adjustable feet up or down. The master switch or the socket point must be in proximity to the appliance and easily

accessible. It is advisable to place the oven under an extractor hood to ensure rapid elimination of steam. If the

appliance is placed near a wall or partition, kitchen furniture or decorative coverings, etc., these must be fire-proof or

coated with fire-proofing. Local fire prevention regulations must be observed. There must be maximum clearance

between the front edge of the cabinet and the appliance.

REGULATIONS, TECHNICAL STANDARDS AND SPECIFICATIONS

Installation must be carried out in accordance with:

•

current accident prevention legislation;

•

current VDE specifications.

The installation, start-up and maintenance of this appliance must be carried out only by qualified fitters. All installation

operations must be in accordance with current regulations. The manufacturer declines all responsibility for

malfunctioning due to bad or faulty installation.

Attention: international regulations require that a omni pole cut-out device with contact opening of at least 3 mm be

fitted on the wiring leading to the appliance.

The terminal board is situated behind the front panel. The electrical wiring must be no less than HO5 RN F and have a

section suitable for the appliance (see 1.1). Secure the wiring with the wiring clips. Connect the wire ends to their

terminals on the terminal board. The earthing wire must be longer than the other wires so that it will disconnect after the

live wires in the event of the fastener breaking.