Crivit HG03469A Montage-Und Sicherheitshinweise Seite 7

Do not use any insect spray in or on the tent.
Small leaks on the seams can be repaired
with a seam spray and impregnation spray
can be used for the tent skin.
m
CAUTION! DANGER OF POISONING
AND DAMAGE TO PROPERTY! Do not
light any fires within the product and keep it
away from sources of heat.
You should also familiarize yourself with the
local fire protection regulations (e.g. camping
site, tent pitch).
Warning! Danger of suffocation!
If the inside of the tent is not adequately
ventilated, there is a risk of suffocation.
Make sure that the vents on the side of the
inner tent are not covered at any time.
Do not leave children unattended in the tent.
The logo on the inner tent
is an access slot for USB cables (for LED
lighting or phone charging).
WARNING! Do not use high voltage
appliances or hot appliances in the
tent, as this may cause fire or electric
shock.
§ Fire precautions
Camp safely. Follow these
commonsense rules:
Do not place hot appliances near the walls,
roof or curtains.
Always observe the safety instructions for
these appliances.
Never allow children to play near hot
appliances.
Keep exits clear. Do not block the exit with
objects.
Make sure you know the fire precaution
arrangements on the site.
6 GB/CY
§ Tent assembly
indicates it
7
Illustration A:
1.
2. Run the two fiberglass poles
Illustration B:
3. Push the fiberglass pole
4. Set the tent
Illustration C:
5. Fix one side of the tent in the ground with
Inside the carrying bag there is a label with
a QR-code. If the QR code is scanned you
will receive details about how to pitch the
product.
Please ensure that the product is only
assembled by people with the appropriate
skills.
Note: The polyester material of the tent
consists of water-repellent material.
It is possible that during the first rainfall
the tent will not be completely watertight.
However, the threads of the tent will contract
when exposed to water so that after a short
time the tent will become watertight.
Erect the product in accordance with the
illustrations A to F.
Place the outer tent
1
The tunnels for the poles
facing upwards.
plastic end forward into the two tunnel
guides on the outer tent one after another
and slide them through to the end.
through the tunnel guide on the awning so
that it extends evenly on both sides of the
tunnel guide.
up and fix the poles to the
1
metal pins of the floor fastenings.
the tent pegs . Then take hold of the other
5
end of the tent and pull it apart in such a
way that the tent is taut.
flat on the ground.
must be
2 3
with the
2
of the awning
3