Use; Warranty - Cattini Oleopneumatica YAK 330/N Bedienungsanleitungen

ACCESSORIES
The jack is supplied with two extensions or height adapters (120 mm the long extension, 70 mm the short extension), a
circular tooth plate (10 mm plate) and an extension holder.
Never use more than two extensions!
consequence of disregard for the above indications and the warranty conditions are invalidated thereof!
SCRAPPING AND DISPOSAL
- The lubricants must be disposed of in compliance with the anti-pollution laws in force.
- Scrapping the jack and its component parts must be carried out by the user in accordance with current laws.

USE

IMPORTANT: It is mandatory that the jack be used or activated in the horizontal position so as not to
compromise its operation.
- Expressly observe the safety rules already described in this manual.
1) Position the jack under the supports as described in the manual of the vehicle the manufacturing company is not
responsible for any break or damage to the lifted vehicle or to persons or property due to an incorrect use of the
jack.
2. The handle positioning lever (A) is on the left in relation to the worker; by moving it upwards the stopping system is
released so the worker can then choose one of the three possible handle positions. DWG. 13
3. When control (B) is in the perfectly central position, the jack is in the idle status.
4. By turning control B, located near the handle, towards the right in relation to the worker, the jack lifts the load.
5. By turning control B, located near the handle, towards the left in relation to the worker, the jack lowers the load. DWG.
13
6. After lifting the load, it is absolutely essential to rest it on the support stands before doing any work under it.
Remember that the jack is a lifting device and not a supporting device!
- The operator's employer will have to provide the necessary training and furnish the necessary information about
the pumping and shifting forces.
- If the distributor breaks during use, work directly on the flow of air, closing the safety cock no. between the quick coupling
of the air inlet and the distributor itself. DWG. 14
- Before working with the jack, it is advisable to perform a few operations with no load in order to acquire the
sensitivity necessary to work safely with the jack.
IMPROPER USE
The air-hydraulic jack has been designed and made to lift transport vehicles. Any other use of the jack, such as for
instance lifting and/or moving persons, is considered to be definitely improper. All use of the jack not in conformity with the
safety rules listed in this manual is considered to be improper use.

WARRANTY

This jack is covered by a 12-month warranty starting from the date the warranty comes into effect or from the date the jack
leaves our factory if it has not already been rendered effective on-line; it covers all manufacturing defects but not transport
expenses, defects caused by improper use or damages suffered during transport. For more details please see the card
attached to this manual.
14
The manufacturer is not liable for any damage resulting as a
EN