Olympus PT-E Series Bedienungsanleitung Seite 16

CAUTION:･ When this product is used in combination with a zoom lens, zooming of cannot be controlled
after the camera has been loaded in the case. Be sure to set the zoom ring of the lens to the
desired focal distance before loading the camera in the case.
Confirm that the camera's power switch is OFF.
While pulling out the zoom dial on the PT-E
series case, slide the camera table with camera
attached as far as it will go into the camera
table mount on the inner side of the case's front
lid.
Push in the PT- E series case's power switch
dial and mode dial knob. Turn the power switch
dial and mode dial knob and confirm that they
can control the camera power ON-OFF and
mode switching. Connect the hot shoe mount
section of the hot shoe cable that has been
connected to the PT-E series case to the hot
shoe of the camera.
Pull out the zoom
dial further.
MENU
E-6
After inserting the camera, turn the camera table
lock lever of the PT- E series case all the way
clockwise to lock the camera table, and then
push in the zoom dial on the PT-E series case.
Attach the rear lid of the PT- E series case and
lock the four buckles (two diagonally located
buckles first, and then the other two diagonally
located buckles). Underwater shooting is now
possible.
MENU