Keysight U1401B Kurzanleitung Seite 11

The U1401A can generate and measure signals simultaneously.
NO TE
While the
disables the U1401A output by placing it in the standby mode
(
Frequency and Frequency Counter
Measurements
Autoscan and autoramp outputs
The voltage and current outputs can also be generated in predefined steps
or ramp. Refer to the User's and Service Guide for the detailed procedures.
mode is enabled, pressing
). Pressing OUTPUT again toggles the output on (
Constant voltage output
1 Set the rotary switch to any one of the
2 Press
appears.
3 Press
±15 V,
modes.
4 Select ±1.5 V or ±15 V.
5 Press
Constant current output
1 Set the rotary switch to any one of the
2 Press
appears.
3 Press
output modes.
4 Select ±25 mA.
Press
5
positions.
. The
to cycle through ±1.5 V,
±1.5 V,
±1.5 V, and
to output the signal.
positions.
. The
to cycle through ±25 mA,
±25 mA, and
to output the signal.
U1401B Quick Start Guide
).
annunciator
±15 V,
±15 V output
annunciator
±25 mA