Vitek VT-2516 W Betriebsanweisung Seite 7

unit with the blades pointed upwards.
Start haircutting from the beginning of
the hair growth. Slowly move the clip-
per upwards. This way cut the head
back area at neck bottom and near the
ears (pic. 1, 2, 3)
Step two
Switch the unit off using the power
switch (1) by setting it to the "OFF"
position, unplug the unit, then set the
9 mm attachment comb (8) for longer
hair or 12 mm attachment comb (9)
and continue cutting hair near top of
the head (pic. 4).
Step three – cutting temples
Switch the hair clipper off and unplug
it, then set the 3 mm attachment comb
(6) or 6 mm attachment comb (7) and
cut hair in the area of the temples.
Then set the 9 mm attachment comb
(8) or 12 mm attachment comb (9)
and continue cutting towards the top
of the head.
Step four – cutting the top
of the head
Using the 9 mm attachment comb (8)
or 12 mm attachment comb (9), cut the
hair on the top of the head towards the
crown against the hair growth direction.
•
•
VT-2516_100 140.indd 7
You can cut hair against and along
the direction of hair growth, but
keep in mind that the hair cut
against the growth will be shorter
than the hair cut along the growth.
Use the 3 mm attachment comb (6)
and 6 mm attachment comb (7) for
very short haircut. To leave longer
hair, use the necessary 9 mm comb
(8) or 12 mm attachment comb (9).
ENGLISH
•
To leave longer hair, take hair locks
between your fingers and cut hair
using the clipper (pic. 5).
•
You can use the comb (11): lift the
hair locks and cut them above the
comb (pic. 6).
•
Always start cutting from the back
of the head.
•
Set the hair with the comb (11) to
reveal uneven locks.
•
Use the scissors (12) to make
haircut even
Step 5 – the final part
–
In the final stage of hair cutting,
remove the attachment comb
from the hair clipper, turn the
blades of the clipper towards
the hair and trim hair on the tem-
ples and neck carefully. Do not
press the clipper strongly, there
is danger of injuries or cuts when
open blades come in contact
with the skin (pic. 7)
–
After finishing hair cutting, put
the protective cover (10) on the
blades (3, 4).
Cone-shaped haircut
Set the necessary attachment comb
and start cutting from the head back
towards the crown. Cut hair against hair
growth from the head front to the crown
and on the head sides (pic. 8). To get
a flat top haircut, use the comb (11):
lift the locks and cut them along the
comb. Set the hair with the comb (11)
to reveal uneven locks.
Note: Between operations, you can
hang the clipper on the hanging loop
(5) having preliminarily switched the
unit off using the power switch (1).
7
09.03.2016 14:51:39