Vitek VT-2516 W Betriebsanweisung Seite 5

•
•
•
•
•
Attention! Do not allow children to
play with polyethylene bags or pack-
aging film. Danger of suffocation!
•
•
THE UNIT IS INTENDED FOR HOUSE-
HOLD USAGE ONLY
VT-2516_100 140.indd 5
During the unit operation do not
allow children under 8 years of
age to touch the unit body, the
power cord or the power plug.
Do not leave children unattend-
ed to prevent using the unit as
a toy.
Close supervision is necessary
when children under 8 years of
age or disabled persons are near
the operating unit.
This unit is not intended for usage
by children under 8 years of age.
Children aged 8 and over as well
as disabled persons can use this
unit only under supervision of a
person who is responsible for
their safety if they are given all
the necessary and understand-
able instructions concerning the
safe usage of the unit and infor-
mation about danger that can be
caused by its improper usage.
Do not use the hair clipper if the
power cord or the plug is dam-
aged or if the hair clipper works
improperly.
Do not repair the unit by your-
self. Do not disassemble the unit
by yourself, if any malfunction is
detected or after it was dropped,
unplug the unit and apply to any
authorized service center from the
contact address list given in the
warranty book and on the website
www.vitek.ru.
ENGLISH
USING THE HAIR CLIPPER
–
After unit transportation or stor-
age at low temperature, it is
necessary to keep it for at least
three hours at room temperature
before switching on.
–
Remove all stickers and packag-
ing elements that can prevent unit
operation.
Blades
–
If the blades have been removed
for cleaning or replacement,
install them back to their places
and tighten the fastening screws.
The unit's design makes it unnec-
essary to level the blades after
installing them.
Lubricating oil
–
To maintain the unit in a good
condition, you should lubricate
the blades regularly. Do not use
vegetable oil or oil that inclu-
des solvents. Solvents are sub-
jected to evaporation, and the
remaining thick oil can slow
down the upper blade (4) mov-
ing speed.
–
For lubricating the blades use
only the oil (13), supplied with
the unit.
Taper lever (2)
–
The taper lever (2), that moves
the lower blade (3), is located
under the thumb (if you are right-
handed). When cutting hair you
can move the blade, pressing
the lever (2), thus adjusting the
cutting length without usage of
the attachment combs. In the
5
09.03.2016 14:51:39