Installation; Motor Installation - MINN KOTA EO-Serie Bedienungsanleitung

Ball Detent
3. Push the outer handle into the control box until handle "clicks" into place. The handle is held in place with locking fi ngers, so
some force may be required to lock the handles together.
4. Once the handle is locked into the control box, it can be rotated and extended for normal use.
5. Once the handle is installed, the assembly is permanent. Do not attempt to remove the handle.
Detent/Wire Clip
Inner Handle
Ball Detent

MOTOR INSTALLATION

1. Find a transom area of the boat that is free from obstructions.
2. Open the clamp screws on the bracket enough so that it will fi t over the top of the
boat transom.
Detent/Wire Clip
3. Place the Lever Lock Mounting bracket over the top of the boat transom so that
the bracket is resting on top of the transom.
MOTOR INSTALLATION
4. Verify that there are no obstacles that the control box, handle, or prop might hit
while in use that would restrict steering or cause damage to the motor.
1. Find a transom area of the boat that is free from obstructions.
TRANSOM EXTRUSION INSTALLATION (PART NUMBER 2994844)
5. Tighten down the clamp screws to the transom by hand only. Do not use any tools
2. Open the clamp screws on the bracket enough so that it will fi t over the top of the
to tighten the clamp screws as this may damage the bracket or your boat.
a. Set the motor on transom with clamp screws backed out.
boat transom.
6. We recommend the tilt angle of the motor to be adjusted so that the motor shaft is
b. Slide extrusion between inside of transom and the clamp
3. Place the Lever Lock Mounting bracket over the top of the boat transom so that
perpendicular to the water surface when the motor is in use.
screw washers and tighten clamp screws.
the bracket is resting on top of the transom.
7. For transport, always tilt the motor into the boat, such that the motor and prop
c. Attach extrusion to transom with two screws provided. This will require
4. Verify that there are no obstacles that the control box, handle, or prop might hit
assembly are completely out of the water and the motor is positioned up close to
drilling two appropriate sized pilot holes for the self tapping screws.
while in use that would restrict steering or cause damage to the motor.
the lever lock bracket.
5. Tighten down the clamp screws to the transom by hand only. Do not use any tools
to tighten the clamp screws as this may damage the bracket or your boat.
NOTE: When setting the depth, be sure the top of the motor is submerged at least
12" to avoid churning or agitation of surface water. The propeller must be completely
6. We recommend the tilt angle of the motor to be adjusted so that the motor shaft is
submerged.
perpendicular to the water surface when the motor is in use.
7. For transport, always tilt the motor into the boat, such that the motor and prop
CAUTION:
assembly are completely out of the water and the motor is positioned up close to
• Never operate your motor when it is out of the water.
the lever lock bracket.
• Over-tightening the clamp screws can damage the bracket.
NOTE: When setting the depth, be sure the top of the motor is submerged at least
12" to avoid churning or agitation of surface water. The propeller must be completely
submerged.
CAUTION:
• Never operate your motor when it is out of the water.
• Over-tightening the clamp screws can damage the bracket.
6 | minnkotamotors.com

INSTALLATION

Outer Handle
Off
Outer Handle
Extrusion
©2015 Johnson Outdoors Marine Electronics, Inc.