Using And Adjusting The Motor; Adjusting The Depth Of The Motor; Adjusting The Steering; Controlling Speed & Direction With The Tiller - MINN KOTA EO-Serie Bedienungsanleitung

USING & ADJUSTING THE MOTOR

ADJUSTING THE DEPTH OF THE MOTOR

When setting the depth be sure the top of the motor is submerged at least
12" to avoid churning or agitation of surface water. The propeller must be
completely submerged.
1. Firmly grasp the composite shaft and hold it steady.
2. Loosen the steering tension knob and adjustable depth collar knob until
the shaft slides freely.
3. Raise or lower the motor to the desired depth.
4. Tighten adjustable depth collar knob to secure the motor in place.
CAUTION:
• Never operate your motor when it is out of the water.
• Over-tightening the clamp screws can damage the bracket.
• Never loosen the steering tension knob without securely
holding the shaft of the motor. Failing to do so will cause the
motor to rapidly fall against the bracket.

ADJUSTING THE STEERING

• Adjust the steering tension knob to provide enough tension to allow the
motor to turn freely, yet remain in any position without being held
• Tighten the knob to place the motor in a preset position to leave your
hands free for fi shing.
ADJUSTING THE BRACKET
You can lock your motor in a vertical position, angle it
for shallow water or tilt it completely out of the water.
1. Firmly grasp the control head or composite shaft.
2. Press the tilt lever down towards the bracket the
shaft and hold to release the T-bar to adjust the
position of the mounting bracket.
3. Tilt to any of the positions on the mounting bracket.
4. Release the tilt lever.
10 | minnkotamotors.com
OR
Transom Clamp Screws
Adjustable Depth Collar Knob
Quick-Release Depth Collar
Steering Tension Knob
Steering Tension Knob
12" Minimum
Depth
12" Minimum
Depth
Quick Release Depth Collar
Tilt Lock Lever
©2015 Johnson Outdoors Marine Electronics, Inc.
Steering Tension Knob
Mounting Bracket