To Enter Admin Mode; To Exit Admin Mode - iStorage datAshur PRO2 Benutzerhandbuch

Note: Once datAshur PRO
only, during which time the datAshur PRO
immediately (if not connected to a USB port) by pressing and holding down the SHIFT (
or by clicking the 'Safely Remove Hardware/Eject' icon within your operating system when connected to a USB
port.
When the datAshur PRO

5. To Enter Admin Mode

To Enter Admin Mode, do the following.
1. Press and hold down the SHIFT (
for one second
2. In Standby State (solid RED
KEY ( ) button once
3. With the GREEN and BLUE
enter the Admin PIN and press the KEY ( ) button
again
4. Press the KEY ( ) button Three times
within 2 seconds (KEY ( ) x 3)

6. To Exit Admin Mode

When the datAshur PRO is in Admin Mode, the
2
can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event happens within 30
seconds, the datAshur PRO will exit Admin mode automatically - the solid
2
to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
switches to a solid RED LED which then fades out to the Idle state. To access the drive contents (data), the
datAshur PRO must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
2
has been successfully unlocked, the
2
needs to be connected to a powered USB port. It can be locked down
2
is unlocked and connected to a USB port, it will not accept further instructions via the keypad.
2
) button
LED) press the
LEDs blinking together,
BLUE LED will remain on and solid for 30 seconds only, during which time the drive
BLUE LED), press and hold down the SHIFT (
www.istorage-uk.com
GREEN LED will remain blinking for 30 seconds
) button for a second
RED, GREEN and BLUE LEDs blink once in
sequence then the GREEN
switches to a solid RED LED indicating the device is in
Standby State
GREEN and BLUE LEDs blink together
GREEN and BLUE LEDs will alternately blink
several times and then to a solid
changing to a blinking GREEN
device is unlocked
Blinking GREEN LED will change to a solid
indicating the device is in Admin mode
BLUE LED switches to a solid
) button for a second - the solid
LED blinks twice and finally
BLUE LED
LED indicating the
BLUE LED
RED LED which then fades out
BLUE LED
#9