How To Check The User Pin Brute Force Limitation - iStorage datAshur PRO2 Benutzerhandbuch

34. How to check the User PIN Brute Force Limitation

The Administrator is able to observe and determine the number of consecutive times an incorrect User PIN is allowed to be entered
before triggering the Brute Force defence mechanism by simply noting the LED sequence as described below.
To check the brute force limitation setting, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
2 + 0 buttons
2. Press the KEY ( ) button and the following happens;
a. All LED's (RED, GREEN
b. Each RED LED blink equates to ten (10) units of a brute force limitation number.
c. Every GREEN LED blink equates to one (1) single unit of a brute force limitation number.
d. All LED's (RED, GREEN
e. LEDs return to solid BLUE
The table below describes the LED behaviour whilst checking the brute force limitation setting, for instance if you have set the drive to
brute force after 5 consecutive incorrect PIN entries, the
Brute Force Limitation Setting
2 attempts
5 attempts
10 attempts
Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
#28
& BLUE) become solid for 1 second.
& BLUE) become solid for 1 second.
GREEN
is in Admin Mode, the
2
will exit Admin mode automatically - the solid
2
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
Solid
BLUE
LED will blink five (5) times.
RED GREEN
0 2 Blinks
0 5 Blinks
1 Blink 0
BLUE LED will remain on and solid for 30 seconds only, during which
www.istorage-uk.com
BLUE LED will change to blinking
LEDs
BLUE LED switches to a solid
) button for a second - the solid
GREEN and
BLUE
2