How To Delete The Self-Destruct Pin; How To Unlock With The Self-Destruct Pin - iStorage datAshur PRO2 Benutzerhandbuch

24. How to Delete the Self-Destruct PIN

To delete the Self-Destruct PIN, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode (solid
LED) proceed with the following steps.
1. In Admin mode, press and hold down both
SHIFT ( ) + 6 buttons
2. Press and hold down SHIFT (
Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

25. How to Unlock with the Self-Destruct PIN

Warning: When the Self-Destruct mechanism is activated, all data, the encryption key and the Admin/User PINs are
When used, the self-destruct PIN will delete ALL data, Admin/User PINs and then unlock the drive. Activating this
feature will cause the Self-Destruct PIN to become the New User PIN and the datAshur PRO
formatted before any new data can be added to the drive.
To activate the Self-Destruct mechanism, the drive needs to be in the standby state (solid
steps.
1. In standby state (solid RED
down both the SHIFT (
2. Enter the Self-Destruct PIN and press the
KEY ( ) button
#22
) + 6 buttons again
is in Admin Mode, the
2
will exit Admin mode automatically - the solid
2
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
deleted. The Self-Destruct PIN becomes the User PIN. No Admin PIN exists after the Self-Destruct
mechanism is activated. The datAshur PRO
Section 35, on page 28) first in order to configure an Admin PIN with
full Admin privileges including the ability to configure a User PIN.
LED), press and hold
) + KEY ( ) buttons
Solid
Blinking
change to a solid
struct PIN was successfully deleted
BLUE LED will remain on and solid for 30 seconds only, during which
will need to be reset (see 'How to perform a complete reset'
2
RED LED switches to all LEDs, RED,
BLUE
RED,
to GREEN
a few seconds and finally shifts to a solid
LED indicating the datAshur PRO
self-destructed
www.istorage-uk.com
BLUE LED will change to a blinking
RED LED will become solid and then
BLUE LED indicating the Self-De-
BLUE LED switches to a solid
) button for a second - the solid
will need to be
2
RED LED) and then proceed with the following
blinking on and off
GREEN and BLUE blinking LEDs will change
and BLUE LEDs alternating on and off for
has successfully
2
BLUE
RED LED
BLUE
2
GREEN &
GREEN