How To Configure A Self-Destruct Pin - iStorage datAshur PRO2 Benutzerhandbuch

Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid RED
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

23. How to configure a Self-Destruct PIN

You can configure a self-destruct PIN which when entered performs a Crypto-Erase on the drive (encryption key is deleted).This process
deletes all configured PINs and renders all data stored on the drive as inaccessible (lost forever), the drive will then show as unlocked
GREEN LED. Running this feature will cause the self-destruct PIN to become the new User PIN and the drive will need to be formatted
before it can be reused.
To set the Self-Destruct PIN, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode (solid
LED) proceed with the following steps.
1. In Admin mode, press and hold down both
KEY ( ) + 6 buttons
2. Configure a 7-15 digit Self-Destruct PIN and
press the KEY ( ) button
3. Re-enter the Self-Destruct PIN and press
the KEY ( ) button
Note:
When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid RED
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
is in Admin Mode, the BLUE
2
will exit Admin mode automatically - the solid
2
LED), press and hold down the SHIFT (
BLUE
LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
is in Admin Mode, the BLUE
2
will exit Admin mode automatically - the solid
2
BLUE LED), press and hold down the SHIFT (
LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
www.istorage-uk.com
LED will remain on and solid for 30 seconds only, during which
) button for a second - the solid
Solid BLUE
solid BLUE LEDs
Blinking GREEN
a single GREEN
GREEN and solid
GREEN LED will rapidly blink for several
seconds and then changes to a solid
to indicate the Self-Destruct PIN has been success-
fully configured
LED will remain on and solid for 30 seconds only, during which
) button for a second - the solid
BLUE LED switches to a solid
LED will change to blinking GREEN
and solid BLUE LEDs will switch to
LED blink and then back to blinking
BLUE LEDs
BLUE
BLUE LED switches to a solid
BLUE
2
BLUE
and
LED
BLUE
2
#21