How To Perform A Complete Reset; How To Configure Datashur Pro; As Bootable - iStorage datAshur PRO2 Benutzerhandbuch

35. How to perform a complete reset

To perform a complete reset, the datAshur PRO
Admin/User PINs, the encryption key and all data will be deleted and lost forever and the drive will need to be formatted before it can be
reused. To reset the datAshur PRO
1. In standby state (solid RED
hold down "0" button
2. Press and hold down both 2 + 7 buttons
Important: After a complete reset a new Admin PIN must be configured, refer to Section 26 on page 22 on

36. How to configure datAshur PRO

Note:
When the drive is set as bootable, ejecting the drive from Operating System will
not force the LED to turn RED. The drive stays solid
next time use. The default setting of the datAshur PRO
iStorage datAshur PRO USB drives are equipped with a bootable feature to accommodate power cycling during a host boot process.
2
When booting from the datAshur PRO
To set the drive as bootable, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode (solid
LED) proceed with the following steps.
1. In Admin mode, press and hold down both
KEY ( ) + 8 buttons
2. Press "0" followed by a "1" (01)
3. Press the SHIFT ( ) button once
Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid RED
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
must be in standby state (solid
2
proceed with the following steps.
2
LED) , press and
to Configure an Admin PIN after a Brute Force attack or
formatted before any new data can be added to the drive.
, you are running your computer with the operating system that is installed on the datAshur PRO
2
is in Admin Mode, the
2
will exit Admin mode automatically - the solid
2
BLUE LED), press and hold down the SHIFT (
LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
RED LED). Once the drive is reset then all
Solid
GREEN
RED, GREEN
become solid for a second and then to a solid
LED indicating the drive has been reset
Reset', the datAshur PRO

as Bootable

2
GREEN and needs to be unplugged for
is configured as non-bootable.
2
Solid
BLUE
GREEN
Blinking
solid
indicating the drive has been successfully config-
ured as bootable
BLUE LED will remain on and solid for 30 seconds only, during which
www.istorage-uk.com
RED LED will change to all LEDs, RED,
and BLUE blinking alternately on and off
and BLUE alternating LEDs will
will also need to be
2
BLUE LED will change to blinking
LEDs
and BLUE LEDs will continue to blink
GREEN and BLUE LEDs will change to a
GREEN LED and finally to a solid
BLUE LED switches to a solid
) button for a second - the solid
RED
'How
.
2
BLUE
GREEN and
BLUE LED
BLUE
2
#29