Adding A New User Pin In Admin Mode - iStorage datAshur PRO2 Benutzerhandbuch

11. Adding a New User PIN in Admin Mode

Important: The creation of a new User PIN must comply with the 'User PIN Policy' if one has been configured as
described in section 8, which imposes a minimum PIN length and whether a 'Special Character' has been used. Refer to
section 10 to check the user PIN restrictions.
PIN requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
• The SHIFT ( ) button can be used for additional PIN combinations - e.g. SHIFT (
than just 1. See section 8, 'Setting a User PIN Policy'.
To add a New User PIN, first enter "Admin Mode" as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
KEY ( ) + 3 buttons
2. Enter New User PIN and press KEY ( ) button
3. Re-enter the New User PIN and press KEY ( )
button again
Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
#14
is in Admin Mode, the
2
will exit Admin mode automatically - the solid
2
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
Solid BLUE
solid BLUE
Blinking
a single
GREEN
Blinking
rapidly blinking
BLUE LED indicating a New User PIN has been
successfully configured
BLUE LED will remain on and solid for 30 seconds only, during which
www.istorage-uk.com
) + 1 is a different value
LED will change to blinking
LEDs
GREEN and solid BLUE LEDs will switch to
GREEN LED blink and then back to blinking
and solid BLUE LEDs
GREEN and solid BLUE LEDs change to a
GREEN LED and finally to a solid
BLUE LED switches to a solid
) button for a second - the solid
GREEN and
BLUE
2