Activating Recovery Mode And Creating New User Pin - iStorage datAshur PRO2 Benutzerhandbuch

Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

18. Activating Recovery Mode and Creating New User PIN

The User Recovery PIN is extremely useful in situations where a user has forgotten their PIN to unlock the datAshur PRO
To activate the recovery mode, the user must first enter the correct One-Time Recovery PIN, if one has been configured. The user PIN
recovery process does not impact the data, encryption key and Admin PIN, however the user is forced to configure a new 7-15 digit User
PIN.
To activate the Recovery process and configure a new User PIN, proceed with the following steps.
1. With the drive in Idle State press and hold down
the SHIFT ( ) button for one second
2. In Standby State press and hold down both
KEY ( ) + 4 buttons
3. Enter the One-Time Recovery PIN and press the
KEY ( ) button
4. Enter the New User PIN and press the KEY ( )
button
5. Re-enter the New User PIN and press the
KEY ( ) button again
Important: The creation of a new User PIN must comply with the 'User PIN Policy' if one has been configured as
described in section 8, which imposes a minimum PIN length and whether a special character has been used. Refer to
section 10 to check the user PIN restrictions.
#18
is in Admin Mode, the
2
will exit Admin mode automatically - the solid
2
LED), press and hold down the SHIFT (
BLUE
RED LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
BLUE LED will remain on and solid for 30 seconds only, during which
RED, GREEN
sequence then the
finally switches to a solid
drive is in Standby State
Solid
GREEN
GREEN
solid GREEN
solid BLUE
Blinking
a single
GREEN
GREEN
GREEN
successful and a new user PIN configured
www.istorage-uk.com
BLUE LED switches to a solid
) button for a second - the solid
and BLUE LEDs blink once in
GREEN LED blinks twice and
RED LED indicating the
RED LED will change to blinking
LEDs
and BLUE LEDs alternate on and off then to a
LED and finally to blinking
LEDs
GREEN and solid BLUE LEDs change to
GREEN LED blink then back to blinking
and solid BLUE LEDs
LED blinks rapidly then becomes solid
indicating the recovery process has been
BLUE
2
.
2
RED and
GREEN and