hanseatic HCD17884A2I Gebrauchsanleitung Seite 76

Page EN-34 Start-up
Do not kink or pinch the mains cable
■
or lay it over sharp edges. This can re-
sult in a break in the cable.
When positioning the appliance, en-
■
sure the supply cord is not trapped or
damaged.
Do not locate multiple portable sock-
■
et-outlets or portable power supplies
at the rear of the appliance.
CAUTION
Fire hazard!
Improper handling of the appliance
can lead to fire and property damage.
Only connect the appliance to a
■
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
NOTICE
Risk of damage!
If the refrigerating appliance has been
transported horizontally, lubricant from
the compressor may make its way into
the cooling circuit.
If possible, do not tilt the refrigerat-
■
ing appliance horizontally.
Allow the appliance to stand upright
■
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to flow
back into the compressor.
• Insert the mains plug into an easily acces-
sible socket (220-240 V~ / 50 Hz).
When you open the door of the refrigera-
tor, you will hear a beeping sound and the
appliance's interior will light up.
The appliance is checked for function-
ality before being delivered. The most
recently made settings are retained. If
the appliance was switched into "holiday
mode" during the functional test, the fridge
will also be switched off upon being plugged
in for the first time.
You will find all important information
about operation from page EN-13.