Cleaning The Ice Cube Maker; Interior Lighting - hanseatic HCD17884A2I Gebrauchsanleitung

Page EN-30 Care and maintenance
(41)
1. Lift the valve of the water dispenser a little
with the help of a thin, flat tool.
2. Pull the valve out with your hand.
3. Wash the water valve (41) with warm wa-
ter. Rinse thoroughly with clear water and
allow it to dry completely.
4. Press the water valve (41) back into the
left fridge door, until you hear a click. To
do this, position the valve at the slit.
5. Place the water tank back into the holder
in the left fridge door. Push the water out-
let with sealing ring into the water valve.
Check whether the sealing ring sits cor-
rectly in the water valve and is properly
clicked in.

Cleaning the ice cube maker

1. Take the ice cube maker (35) and the ice
cube collecting container (37) out of the
freezer.
2. Remove the cover (33) of the ice cube
container.
(41)
3. Wash the ice cube maker (35), the ice
cube collecting container (37) and the
lid (33) with warm water.
4. Rinse thoroughly with clear water and al-
low everything to dry completely.

Interior lighting

WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
(41)
Do not remove the covers from the in-
■
terior lighting.
Do not try to replace the interior
■
lighting or lighting at the ice/cold wa-
ter outlet yourself.
The interior lighting (1) switches on automat-
ically when the door is opened and goes out
when the door is closed.
Maintenance-free LEDs are used to illumi-
nate the appliance. If the lighting fails, contact
an authorised professional (see "Service" on
page EN-37).
(33)
(35)
(37)