General Information - Carrier HDB series Installationsanweisung

HDB - IR

General information

The remote control operates with two 1.5 V non re-chargeable
batteries.
When the symbol appears in the display, this indicates that
the batteries are exhausted.
How to insert batteries:
Open embedded cover. Remove the cover of the battery
compartment at the back of the remote control by pressing the tab
toward inside, in the direction of the arrow.
A 1
B 2
AM
PM
C
F
I
L
o
A
A 1
f
B 2
AM
PM
A
f

a
B
D
E
G
H
J
K
M
N
• Remove the used batteries and insert new batteries.
The remote control uses two alkaline batteries (1.5 V, LR03x2).
• Press the reset button "o" with a sharp object to reset the remote
control.
• Do not use used batteries or batteries of different types, as this
may cause the unit to malfunction.
• The average battery life during normal use is approximately one
year. The remote control used batteries must be disposed of
according to the standards in force.
• If the air conditioner does not operate normally after replacing the
batteries, remove the batteries, refit them and press the
reset button "o" again after 5 seconds.
The maximum operating range for the remote control is approx. 5 m.
No obstructions such as curtains or plants should be between
control and unit.
Direct sun on the unit receiver may interfere with good signal
reception.
The control must be directed toward the unit receiver when
pressing the buttons of the desired functions. An acoustical
acknowledgement sound (beep) will indicate that signal has been
received.

a.
B.
C.
D.
E.
F.
G.
H.
I.
J.
K.
L.
M.
N.
o.
E N G L I S H
BEEP
Display readout
Mode selection button
On/Off button
Increase temperature button
Decrease temperature button
fan speed selection button
Personalised control button
Personalised settings button
Louvre control button (Flap)
On timer button
DaILy timer button (Everyday)
Cancel timer button
Off timer button
Sleep timer button (night)
Current time adjusting button
Reset button
GB - 3