Changing The Battery - Dentsply Maillefer X-SMART EASY Gebrauchsanweisung

I. CHANGING THE BATTERY
X–SMART
™
Easy
cycles, depending on the conditions of the motor handpiece. If the operating time or
recharging time becomes shorter, replace the battery (refer to the "Changing Battery").
When replacing, be sure to observe the following "PRECAUTIONS ON CHANGING
THE BATTERY". Note that Dentsply shall not be held liable for any malfunction resulting
from the failure to follow the "PRECAUTIONS ON CHANGING THE BATTERY."
PRECAUTIONS ON CHANGING THE BATTERY
• Do not open any part other than the battery door.
• Be sure to purchase and use only a Dentsply replacement battery. Otherwise, battery may
cause damage or explode.
• Do not change the battery with wet hands. This may cause trouble due to short-circuiting of
batteries and moisture infiltrating this product.
Changing Battery
1. Turn off the power.
2. Remove the plug. (Fig. 11)
3. Unscrew the battery cover. Lift the battery cover off the back of the handpiece. (Fig. 12)
Pull the battery and connector out of the opening as shown in Fig. 13 and Fig 14.
PRECAUTIONS
While disconnecting the battery, ensure you press on the connector lever to separate the
connector halves. Failure to do so may cause a break in the cord.
uses a rechargeable battery. It can be recharged 300-500 full
Fig. 11
Fig. 13
Plug
Screw
Lift here
to remove
battery door
Fig. 12
Fig. 14
21