Preparing The Motor Handpiece For Use; Connecting The Power Cord; Charging The Battery; Connecting And Disconnecting The Contra-Angle Attachment - Dentsply Maillefer X-SMART EASY Gebrauchsanweisung

E. PREPARING THE MOTOR HANDPIECE FOR USE

1. Connecting the Power Cord

Securely insert the AC power cord into the
charging stand. Securely insert the AC
power cord into a wall receptacle. (Fig. 3)

2. Charging the Battery

The X–SMART
™
into the charging stand, the light turns yellow indicating the unit is charging. When
the battery is fully charged, the light will turn green.
PRECAUTION
• Connect to AC 100-240V power only. Otherwise, malfunction will occur.
• The standard charging time is about 1 1/2 hours, but it varies depending on use, condition of
battery, temperature, and if the battery is new or old.
• Notice: Older battery shortens both the charging and operating time.

3. Connecting and Disconnecting the Contra-Angle Attachment

• The contra-angle attachment can be connected to
the motor handpiece at 6 adjustable head positions.
Align the positioning pins of the contra-angle
attachment with the positioning slots of the motor
handpiece and insert the head until they click.
• When removing the contra-angle attachment, pull it
straight out. (Fig. 4)
PRECAUTION
• Before attaching and detaching the contra-angle attachment, turn the power off.
• Check that the contra-angle attachment is securely assembled to the motor handpiece.
• Before first use complete the calibration per Section E.5.
12
is delivered with a rechargeable battery. Put the handpiece
Easy
Fig. 3
Fig. 4