Speci Cations - Briggs & Stratton Murray EMT1838RDF Bedienungsanleitung

Specifications
ENGINE
Briggs & Stratton
Make
Displacement
Electrical System
Oil Capacity
Spark Plug Gap
Spark Plug Torque
Spark Plug, EMS "X"
Briggs & Stratton
Make
Displacement
Electrical System
Oil Capacity
Spark Plug Gap
Spark Plug Torque
Spark Plug, EMS "X"
Power rating
The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive En-
gineers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained and
corrected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower values
are derived at 3600 RPM. The gross power curves can be viewed at www.BRIGGSandSTRATTON.COM. Net power val-
ues are taken with exhaust and air cleaner installed whereas gross power values are collected without these attachments.
Actual gross engine power will be higher than net engine power and is a ected by, among other things, ambient operating
conditions and engine-to-engine variability. Given the wide array of products on which engines are placed, the gas engine
may not develop the rated gross power when used in a given piece of power equipment. This di erence is due to a variety
of factors including, but not limited to, the variety of engine components (air cleaner, exhaust, charging, cooling, carbure-
tor, fuel pump, etc.), application limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-
engine variability. Due to manufacturing and capacity limitations, Briggs & Stratton may substitute an engine of higher rated
power for this Series engine.
Parts and accessories
Contact an authorized dealer for details.
30
Briggs & Stratton®,
TM
Intek Series 4175 OHV
500 cc (30,5 cu in.)
Battery: 12 Volt, 190 CCA
Alternator: 9 amp
1,4 L (48 oz)
0,76 mm (0.030 in.)
20 Nm (180 in-lbs)
792015
Briggs & Stratton®,
Intek Series TM 7180 OHV
656 cc (40,03 cu in.)
Battery: 12 Volt, 190 CCA
Alternator: 9 amp
1,9 L (64 oz)
0,76 mm (0.030 in.)
20 Nm (180 in-lbs)
792015
CHASSIS
Fuel Tank Capacity
Front Wheels
Rear Wheels
TRANSMISSION
Type
Engine Oil
Speeds
@ 3400 rpm
Continuous Torque
Output
MOWER
Width of Cut
Number of Blades
Base Deck Platform
Cutting Height
Cutting Positions
6,0 L (1,5 gal)
Tire Size: 15 x 6.0
In ation Pressure: 14 psi (0,96 bar)
Tire Size: 20 x 8,0
In ation Pressure: 10 psi (0,68 bar)
Hydrostatic Hydro Gear
Synthetic 5W30
Forward: 0-9,0 km/h (0-5,6 mph)
Reverse: 0-4,5 km/h (0-2,8 mph)
233 Nm (172 ft-lbs)
96,5 cm (38")
2
Rear Discharge
2,5-8,9 cm (1,0-3,5")
6