Maintenance - Briggs & Stratton Murray EMT1838RDF Bedienungsanleitung

Maintenance

Maintenance Chart
TRACTOR AND MOWER
Every 8 Hours or Daily
Check safety interlock system
Clean debris o tractor and mower deck
Clean debris from engine compartment
Every 25 Hours or Annually *
Check tire pressure
Check mower blade stopping time
Check tractor and mower for loose hardware
Every 50 Hours or Annually *
Clean battery and cables
Check tractor brakes
See Dealer Annually to
Lubricate tractor and mower
Check mower blades **
* Whichever comes rst
** Check blades more often in regions with sandy soils or
high dust conditions.
Emissions Statement
Maintenance, replacement, or repair of the emissions control
devices and systems may be performed by any non-road
engine repair establishment or individual. However, to obtain
"no charge" emissions control service, the work must be per-
formed by a factory authorized dealer.
Check Tire Pressure
Tires should be checked periodically to provide the
optimum traction and to guarantee the best cut (see
Figure 4).
NOTE: These pressures may di er slightly from the
"Maximum In ation" stamped on the side walls of the tires.
24
ENGINE
First 5 Hours
Change engine oil
Every 8 Hours or Daily
Check engine oil level
Every 25 Hours or Annually *
Clean engine air lter and pre-cleaner **
Every 50 Hours or Annually *
Change engine oil
Replace oil lter
Annually
Replace air lter
Replace pre-cleaner
See Dealer Annually to
Inspect mu er and spark arrester
Replace spark plug
Replace fuel lter
Clean engine air cooling system
* Whichever comes rst
** Clean more often in dusty conditions or when airborne
debris is present.
WARNING
Unintentional sparking can result in re or elec-
tric shock.
Unintentional start-up can result in entangle-
ment, traumatic amputation, or laceration.
Before performing adjustments or repairs:
• Disconnect the spark plug wire and keep it away
from the spark plug.
• Disconnect battery at negative terminal (only en-
gines with electric start).
• Use only correct tools.
• Do not tamper with governor spring, links, or other
parts to increase engine speed.
• Replacement parts must be of the same design and
installed in the same position as the original parts.
Other parts may not perform as well, may damage
the unit, and may result in injury.
• Do not strike the ywheel with a hammer or hard ob-
ject because the ywheel may shatter during opera-
tion.