Briggs & Stratton Murray EMT1838RDF Bedienungsanleitung Seite 27

Washing the Mower Deck
NOTE: The washout port allows you to connect a typical
garden hose to the mower deck to remove grass and debris
from the underside. This ensures proper and safe operation
of the mower.
WARNING
Before running the mower, make sure the hose is
properly connected and does not come into con-
tact with the blades. When the mower is running
and the blades are engaged, the person cleaning
the mower deck must be in the operator position, and
there are no bystanders. Failure to follow these precau-
tions may result in serious injury or death.
1. Place the tractor on a level surface.
2. Attach the quick disconnect (not included) (A, Figure 16)
to garden hose (B) and connect to washout port (C) on
on either side of mower deck.
3. Run water to remove grass and debris from underside of
mower deck.
4. Turn the mower on and place in the highest cutting posi-
tion.
5. Stop the engine (see Stopping the Tractor and En-
gine).
6. Remove the garden hose and quick disconnect from the
washout port when completed.
7. Repeat for washout port on other side.
en
Storage
WARNING
Never store the unit (with fuel) in an enclosed, un-
ventilated structure. Fuel vapors can travel to an
ignition source (such as a furnace, water heater,
etc.) and cause an explosion. Fuel vapor is also
toxic to humans and animals.
When Storing Fuel Or Equipment With Fuel in Tank
• Store away from furnaces, stoves, water heaters, or
other appliances that have pilot lights or other ignition
sources because they can ignite fuel vapors.
Equipment
Disengage the PTO, set the parking brake, and remove
the key.
Battery life will be increased if it is removed. Put in a cool,
dry place and fully charged about once a month. If the bat-
tery is left in the unit, disconnect the negative cable.
Fuel System
Fuel can become stale when stored over 30 days. Stale
fuel causes acid and gum deposits to form in the fuel sys-
tem or on essential carburetor parts. To keep fuel fresh,
use Briggs & Stratton® Advanced Formula Fuel Treat-
ment & Stabilizer, available wherever Briggs & Stratton
genuine service parts are sold.
For engines equipped with a FRESH START® fuel cap,
use Briggs & Stratton FRESH START® available in a
drip concentrate cartridge.
There is no need to drain gasoline from the engine if a
fuel stabilizer is added according to instructions. Run the
engine for 2 minutes to circulate the stabilizer throughout
the fuel system before storage.
Engine Oil
While the engine is still warm, change the engine oil. See
Changing the Oil section.
Before starting the unit after it has been stored:
• Check all uid levels. Check all maintenance items.
• Perform all recommended checks and procedures
found in this manual.
• Allow the engine to warm up for several minutes before
use.
27