Orbis Athena Bedienungsanleitung Seite 62

Standard zone confi guration:
zone n°
1
2
3
4
Existence of external sensor
• When the key is pressed from the zone 4
confi guration menu, the menu showing the existence of
the external sensor is displayed.
• TIt is used to confi gure the presence of the external
temperature sensor (optional) By default, this parameter
is confi gured to "no". Press [OK] to modify the
parameters, the
[OK] again to confi rm it.
ºC/ºF measurement unit
• When the key is pressed again, the displayed
temperature measurement unit selection menu is
entered.
• By default, this is confi gured with ºC. Press [OK] to
modify the parameters, the
and press [OK] again to confi rm it.
• Modifying this parameter performs the automatic conversion of all temperature
parameters.
Unit bus address
• Press the key again to enter the device address
menu.
• Each device connected to the bus is uniquely defi ned by
an address, which is shown in this menu.
WARNING: maintaining the [OK] key pressed for at least three minutes will
generate a new address; after modifying the address, all bus peripheral and
wireless devices will require reconfi guration.
description
ZONE 1
ZONE 2
ZONE 3
ZONE 4
and arrows to select it and press
and arrows to select it
- 60 -
Instruction Manual
sensor
inretnal
-
-
-
Athena
actuator
relay
-
-
-
ADV
ADV
ADV