Initial Reset; Time Confi Guration - Orbis Athena Bedienungsanleitung

15 Measured temperature
16 Measurement or obtaining current temperature
17 ºC/ºF measurement unit
18 Manual operation
19 Wireless fi le presence
20 Active prolongation program
21 Telephone combiner input status
Keys (Figure 2):
• 1: outout key
• 2: joystick, press in the centre for [OK]
press the side for
• 3: manual operating keys

INITIAL RESET

• After inserting the batteries, press the reset key [R] (see the drawing "battery
installation and location" on page 65). This operation does not delete any of the
previously confi gured programs, only the date and time.
• All screen segments are on, energising the relay for approximately three seconds.
• The screen will sequentially go out and light up again, displaying the fl ashing time.
• The clock will work normally, however, the adjustment will be disabled until the time is
confi gured.
Note: to re-establish the unit's default, the [R] must be pressed immediately
followed by the [OK] key.
TIME CONFIGURATION
• Press the joystick at the centre for [OK], and to go to the
fi rst date and time confi guration menu, indicated by the
symbol . The side screen will be displayed.
• Pressing the [OK] key will permit the displayed fi elds to
the modifi ed.
• The fi eld that has to be modifi ed will begin to fl ash. The
fi eld can be increased or decreased with
confi rm the fi eld and move on to the next
• The modifi able fi elds are:
° seconds: press
the minutes
and increase minutes, press
° hh:mm
° DD.MM.AAAA
, , ,
and will set it to 0 and increase
to set them to 0
- 48 -
Instruction Manual
,
Figure 2
and will
and .
ESC ESC
Athena