Timer Programming - Orbis Athena Bedienungsanleitung

TIMER PROGRAMMING

• From this menu, indicated by the symbol
ON/OFF parameters (count-down), together with the display of the current installation
zone operating hours.
• When programming installation switch-on, all the zones are in the OFF state until the
programmed date, after which, each will enter the operating mode prior to switch off.
The symbols and
• When programming installation switch-off, all zones will enter OFF status on the
programmed date. The symbol
Note: setting the programmed date to zero will exit the switch on/off
countdown mode before the time fi nalises.
• Switch on or off is performed at 00:00. The countdown program acts in all
adjustment zones simultaneously.
• Press [OK] from the timer programming menu to confi gure the countdown program.
ESC ESC
• Press the and
• Confi gure the date by moving through the date fi eld with the
modify the values with the
the date has not been confi gured. After confi guring, press [OK] ] to confi rm. Press the
key to re-establish the main display screen.
Note: the countdown program cannot be enabled once the extension program
has commenced.
• To display the installation operating hours, press the
programming menu. The operating hours refer to the temperature zone displayed
before accessing the menu.
Note: The hour counter for the current zone can be zeroed by pressing the [OK]
key for approximately three seconds from the hour counter display menu. The
maximum that can be stored is 65,535 hours.
will be shown onscreen in this operating mode.
will be shown onscreen in this operating mode.
ESC ESC
keys to select one of the switch on or off modes.
and . If [--.--.----] appears in the date fi eld, it means
- 56 -
Instruction Manual
, it is possible to establish the installation
ESC ESC
and
or keys from the timing
Athena
arrows and