Getting Started; Boiling Water - Silvercrest SRWK 2400 A1 Bedienungsanleitung Und Serviceinformationen

Getting started

Before preparing water for consumption, you must first clean the kettle (7) to remove dust and any
residues from the packaging materials. Proceed as follows:
1. Remove the lid (1) and rinse the kettle (7) with clean water.
2. Fill the kettle (7) with drinking water up to the "1.8L MAX" mark.
3. Replace the lid (1), allow the water to boil once (see next step "Boiling water") and pour it away.
4. Repeat steps 1 to 3 once more. The kettle is then clean and disinfected and ready for use.

Boiling water

Risk of electric shock!
Keep the base (5) away from water. This could result in potentially fatal electrocution.
Warning
On the very first use, boil and pour away water twice (see previous step "Getting started").
Warning
Always use fresh drinking water. Discard any water left to stand in the electric kettle for longer
than one hour.
1. Unwind the power cord (2) underneath the base (5).
2. Place the base (5) on an even, non-slip and dry surface. In so doing, make sure that the power cord
(2) is fed through one of the notches provided on the underside of the base (5).
Warning
If the power cord (2) is not fed through one of the notches provided on the underside of the
base (5), the base (5) and kettle (7) will not be stable. Thus the movement of the boiling water
could make the appliance tip over causing severe damage to property and personal injury!
3. Remove the lid (1).
4. Fill the kettle (7) with drinking water, at least 0.7l (see metal strip inside the kettle) and up to the
"1.8L MAX" mark on the water level indicator (3) at most, and replace the lid (1) on the kettle (7).
When the kettle (7) is placed on the base (5), it can be freely rotated 360° around the
vertical axis. It does not need to engage in a certain position. This allows you to rotate the
kettle (7) such that you can easily check the water level indicator (3) and rotate the kettle (7)
so that the steam is directed away from you.
5. Connect the power cord (2) to a wall outlet.
6. Place the kettle (7) on the base (5) and press the On/Off Switch (4) down into the "I" position to
switch the electric kettle on.
SilverCrest SRWK 2400 A1
English - 11