Philips AC4002 Benutzerhandbuch Seite 20

ENGLISH
20
1
2
Filter
Filter 2: Multi-care filter
Filter 3: Activated carbon filter
Filter 4: HEPA filter
11 Put filter 1 (pre-filter) back into the appliance.
Note: Make sure that the side with the two projections points towards you.
Note: Make sure that all hooks are properly attached to the appliance.
12
To reattach the front panel, insert the two hooks into the top of
the appliance first (1). Then push the panel against the body of the
appliance (2).
13 Put the plug in the wall socket and switch on the appliance again.
14
Press and hold the reset button below the filter replacement light of
the filter you have replaced to reset the appliance.
- Press and hold the reset button for filter 2 for 2 seconds if you have
replaced filter 2 (Multi-care filter).
- Press and hold the reset button for filter 3/4 for 2 seconds if you have
replaced filter 3 (Activated carbon filter) and 4 (HEPA filter).
• You hear a beep and the appliance starts operating in the auto mode
again.
Accessories
New filters are available under the following type numbers:
Type number
AC4121
AC4123
AC4124