Philips AC4002 Benutzerhandbuch Seite 17

This air purifier is also equipped with the Healthy air protect lock to ensure
that the filters are in optimal condition when the appliance is operating.
When you do not replace filter 2 (AC4004 only), filter 3 and/or filter 4, the
appliance stops operating and the appliance is locked. When the appliance
is locked, the filter replacement light of the filter concerned and the
'REPLACE FILTER' light light up continuously.
Filter cleaning light and filter replacement lights
The filter cleaning light and the filter replacement lights indicate which filter
has to be cleaned or replaced.
- Filter cleaning light 1 flashes: you have to clean filter 1 (pre-filter). See
chapter 'Cleaning' for further instructions.
- Filter replacement light 2 and the 'REPLACE FILTER' light flash: filter 2
(Multi-care filter, AC4004 only) has to be replaced.
- Filter replacement light 3/4 and the 'REPLACE FILTER' light flash: filter 3
(Activated carbon filter) and filter 4 (HEPA filter) have to be replaced.
Note: Filter 3 (Activated carbon filter) and filter 4 (HEPA filter) have a similar
lifetime. Therefore they have to be replaced at the same time.
Filter replacement lock
If you do not replace a filter in time, the appliance stops operating approx.
2 weeks after the filter replacement light started flashing. When the
appliance is locked, it does not operate until you have replaced the full filter
and pressed the reset button.
Note: The time between the filter replacement signal and the locking of the
appliance varies, depending on how often you use the appliance.
ENGLISH
17