F - Replacing The Squeegee Rubber Blades - Wirbel SW1 450M ECO Gebrauch Und Wartung

EN
10.1.f - Replacing the squeegee rub-
ber blades (Fig. 21)
When it becomes clear that drying the floor
is difficult or traces of water remain on the
floor, it is necessary to check the wear on the
squeegee rubber blades (1):
- Remove the squeegee unit (1) as indicat-
ed in the "Cleaning the squeegee" para-
graph.
- Press the locking device (2) and open the
handle (3).
- Remove the two rubber mounting strips
(4) and remove the outer rubber (5).
- Loosen the two turnbuckles (6) and re-
move the locking bar (7) and the inside
rubber (8).
N.B.:
When the rubber blades (5) or (8) are worn
on one side, on one occasion they may be
turned over.
- Replace or turn over the rubber blades
(5) or (8) without inverting them.
- Replace all the components in reverse
order.
N.B.:
It is possible to have two types of rubber
blade.
Para rubber blades for all types of floor and
polyurethane rubber blades for mechanical
workshop floors which are dirty with oil.
7
8
6
EN-24
4
5
4
4
5
8
7
8
4
1
2
3
Fig. 21