C - Installing And Connecting The Batteries - Wirbel SW1 450M ECO Gebrauch Und Wartung

3.1.c - Installing and connecting the
batteries (Fig. 5)
WARNING:
Check that the recovery tank and the
clean water tank are empty.
- Disconnect the plug (1).
- Remove the split pin (2) and lift up the
tanks (3), using the handle (4) until they
are completely overturned.
- Position the batteries (5) as shown in the
figure and connect them as shown on the
chart in Fig. 5 using the cables supplied.
- Tighten the terminals (6) using an insu-
lated wrench.
- Lower the tanks (3) and reposition the
split pin (2).
- Connect the plug (1).
N.B.:
The battery must be connected by special-
ised personnel.
3
5
1
6
EN-9
EN
3
4
2
Fig. 5