D - Adjusting The Suction Pressure; E - End Of Use And Switching Off - Wirbel SW1 450M ECO Gebrauch Und Wartung

8.1.d - Adjusting the suction pres-
If during cleaning operations, we realize that on
the floor remain liquid traces, it is possible that
the floor wiper pressure needs to be increased.
- To adjust the wiper pressure, turn the
wheel (4).
- Turning the wheel (4) to "A" , the pressure
increases, turning it backwards to "B" the
pressure drops.
The correct pressure is when the two rubbers
(5) are positioned as shown.
1

8.1.e - End of use and switching off

- Once the cleaning operations have been
completed, do not shut off the machine
immediately: use switches (6) and (7) to
deactivate water dispensing and brush ro-
tation and continue with the suction unit in
function in order to eliminate any residual
liquid on the floor. When finished, press the
switch (8) to shut off the suction unit.
- Lift up the floor squeegee (9) by lifting up
the lever (10), hooking it in the specific
fixing clip (11).
- Lift up the brush by pressing the pedal
(12) as far as it will go, fitting it in the des-
ignated slot.
WARNING:
Always lift up the squeegee at the end of
cleaning in order to prevent the deforma-
tion of the rubber blades.
- Press switch (13) to "0" to stop the ma-
chine.
sure (Fig. 13)
(Fig. 13)
11
5
8
10
12
EN-17
A
4
5
7 13 6
9
EN
B
4
Fig. 13