Backlight Timer; Loss Of Data; Fan Speed; Color Mixing Mode - Chauvet Professional Maverick Storm 1 Wash Schnellanleitung

Operation

Backlight Timer

To set the amount of time after inactivity before the display backlight turns off:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Backlight Timer.
3. Press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select 30S (after 30 seconds of inactivity), 1M
(after 1 minute of inactivity), 5M (after 5 minutes of inactivity), or ON (does not turn off).
5. Press <ENTER>.

Loss of Data

In case of an input signal being lost in any way, the Maverick Storm 1 Wash will respond in one of two
ways: The product will either hold the last signal received or black out all LED output.
To set which way the product responds, follow the instructions below:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Loss of Data.
3. Press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Hold (hold last signal received) or Close
(black out all LED output).
5. Press <ENTER>.

Fan Speed

To set the speed of the fans, do the following:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Fans.
3. Press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Auto (fan speed set according to product
temperature), Full (maximum speed), or ECO (quiet fans mode).
5. Press <ENTER>.

Color Mixing Mode

The Maverick Storm 1 Wash has a mode that emulates CMY (cyan, magenta, and yellow) color mixing. In
this mode, the dimming is reversed (000=100%, 255=0%), and the red, green, and blue channels control
cyan, magenta, and yellow, respectively.
To set the color mixing mode:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select C Mixing Mode.
3. Press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select RGBW (additive mode: red, green, blue,
and white), or CMY (subtractive mode: red controls cyan, green controls magenta, blue controls
yellow).
5. Press <ENTER>.

Dimmer Curve

To set the dimmer curve, follow the instructions below:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Dimmer Curve
3. Press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Linear, Square, I Squa, or SCurve.
5. Press <ENTER>.

Dimmer Speed

To set the dimmer speed, do the following:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Dimmer Speed.
3. Press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Smooth or Fast.
5. Press <ENTER>.
Maverick Storm 1 Wash User Manual Rev. 2
menu.
menu.
menu.
menu.
menu.
menu.
Page 52 of 306