Setup; Ac Power; Ac Plug; Fuse Replacement - Chauvet Professional Maverick Storm 1 Wash Schnellanleitung

Setup

3. Setup

AC Power

The Maverick Storm 1 Wash has an auto-ranging power supply, and it can work with an input voltage
range of 100 to 240 VAC, 50/60 Hz. To determine the product's power requirements (circuit breaker, power
outlet, and wiring), use the current value listed on the label affixed to the product's back panel, or refer to
the product's Technical Specifications. The listed current rating indicates the product's average current
draw under normal conditions.
• Always connect the product to a protected circuit (a circuit breaker or fuse). Make sure
the product has an appropriate electrical ground to avoid the risk of electrocution or
fire.
• To eliminate unnecessary wear and improve its lifespan, completely disconnect the
product from power via breaker or by unplugging it during periods of non-use.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.

AC Plug

The Maverick Storm 1 Wash comes with a power input cord terminated with a Seetronic Powerkon
connector on one end and an Edison plug on the other end (U.S. market). If the power input cord that
came with your product has no plug, or if you need the change the plug, use the table below to wire the
new plug.
Connection
AC Live
AC Neutral
AC Ground

Fuse Replacement

1. Disconnect the product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse from the holder and replace with another fuse of the same type and rating
(F 20 A, 250 V).
4. Screw the fuse holder cap back in place and reconnect power.
Disconnect the product from the power outlet before replacing the fuse.
Always replace a blown fuse with one of the same type and rating.

Power Linking

The Maverick Storm 1 Wash supports power linking. You can power link up to 3 products at 120 V, up to 6
products at 208 V, or up to 7 products at 230 V.
This product comes with a power input cord. Power-linking cables are available from Chauvet for
purchase.

Remote Device Management

Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate
bi-directionally along existing DMX cabling. Check the DMX controller's User Manual or with the
manufacturer as not all DMX controllers have this capability. The Maverick Storm 1 Wash supports RDM
protocol that allows feedback to make changes to menu map options.
Maverick Storm 1 Wash User Manual Rev. 2
Wire (U.S.)
Black
White
Green/yellow
Wire (Europe)
Brown
Blue
Green/yellow
Screw Color
Yellow/brass
Silver
Green
Page 5 of 306