Protocol Configuration; Control Personalities; Single Control; Single Control Protocol - Chauvet Professional Maverick Storm 1 Wash Schnellanleitung

Operation

Protocol Configuration

The Maverick Storm 1 Wash can be set to respond to DMX, WDMX, Art-Net™, sACN, Kling-Net, or a
combination of those protocols. The protocol configuration must be set for the product to respond correctly
to the controller(s).

Control Personalities

The following control personalities are available on the Maverick Storm 1 Wash:

Single Control

Basic (20-channel)
Standard (96-channel)
Advanced (178-channel)
Tour (216-channel)
Uses DMX, Art-Net™, sACN,
or WDMX
Single Control
In Single Control mode, the Maverick Storm 1 Wash is controlled by a single protocol input. Choose from
DMX, Art-Net™, sACN, or WDMX. In this mode, the four personalities available are: Basic (20 channels),
Standard (96 channels), Advanced (178 channels), and Tour (216 channels).

Single Control Protocol

To select the Single Control protocol, follow the instructions below:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Control Settings.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Single Control.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select from DMX, ArtNet, sACN, or WDMX.
7. Press <ENTER>.

Single Control Personality

To select the Single Control personality, set the Protocol, then do the following:
1. Use <UP> or <DOWN> to select Personality.
2. Press <ENTER>.
3. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select from Basic (20-channel), Standard (96-
channel), Advanced (178-channel), or Tour (216-channel).
4. Press <ENTER>.
For WDMX control, ensure the antenna is raised, and there are no obstructions between
the controller and the product. See

Single Control Start Address

To set the starting address of the Single Control mode, set the Protocol, then follow the instructions below:
1. Use <UP> or <DOWN> to select Start Address.
2. Press <ENTER>.
3. Enter the starting address (1–512) with one of the following methods:
a. Use <LEFT> or <RIGHT> to select the digit to be altered.
b. Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c. Repeat until the address is set as desired.
4. Press <ENTER>.

Single Control Universe

To set the Universe address of the Single Control mode when using Art-Net™ or sACN, set the
ArtNet or sACN, then do the following:
1. Use <UP> or <DOWN> to select Universe.
2. Press <ENTER>.
3. Enter the universe address (0–255 for Art-Net™, 1–256 for sACN,) with one of the following methods:
a. Use <LEFT> or <RIGHT> to select the digit to be altered.
b. Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c. Repeat until the address is set as desired.
4. Press <ENTER>.
Maverick Storm 1 Wash User Manual Rev. 2
Dual Control Movement
Basic (8-channel)
Standard (20-channel)
Advanced (26-channel)
Uses DMX, Art-Net™, or sACN
Home Screen shows on the display. Press <ENTER>.
WDMX Reset
Dual Control Pixels
Basic (57-channel)
Standard (76-channel)
Advanced (152-channel)
Uses DMX, Art-Net™, sACN,
or Kling-Net
for troubleshooting information.
Protocol to
Page 14 of 306