Backlight Timer; Loss Of Data; Fan Speed; Color Mixing Mode - Chauvet Professional Maverick MK2 Wash Schnellanleitung

Backlight Timer

To set the amount of time after inactivity before the display backlight turns off:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Backlight Timer, or touch the display where it says Backlight
Timer.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select 30S (after 30 seconds of inactivity), 1M
(after 1 minute of inactivity), 5M (after 5 minutes of inactivity), or ON (does not turn off), or touch
the display where it says the desired option.
5. Press <ENTER>.

Loss of Data

In case of an input signal being lost in any way, the Maverick MK2 Wash will respond in one of two ways.
the product will either hold the last signal received, or black out all LED output.
To set which way the product responds, follow the instructions below:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Loss of Data, or touch the display where it says Loss of Data.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Hold (hold last signal received) or Close
(black out all LED output), or touch the display where it says the desired option.
5. Press <ENTER>.

Fan Speed

To set the speed of the fans, do the following:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Fans, or touch the display where it says Fans.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Auto (fan speed set according to product
temperature), Full (maximum speed), or ECO (quiet fans mode), or touch the display where it says
the desired option.
5. Press <ENTER>.

Color Mixing Mode

The Maverick MK2 Wash has a mode that emulates CMY (cyan, magenta, and yellow) color mixing. In this
mode, the dimming is reversed (000=100%, 255=0%), and the red, green, and blue channels control cyan,
magenta, and yellow, respectively.
To set the color mixing mode:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select C Mixing Mode, or touch the display where it says C Mixing
Mode.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select RGBW (additive mode: red, green, blue,
and white), or CMY (subtractive mode: red controls cyan, green controls magenta, blue controls
yellow), or touch the display where it says the desired option.
5. Press <ENTER>.

Dimmer Curve

To set the dimmer curve, follow the instructions below:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Dimmer Curve, or touch the display where it says Dimmer
Curve.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Linear, Square, I Squa, or SCurve, or
touch the display where it says the desired option.
5. Press <ENTER>.
Page 45 of 275
menu.
menu.
menu.
menu.
menu.
Maverick MK2 Wash User Manual Rev. 10
Operation