Pan/Tilt Angle Range; Blackout On Pan/Tilt Movement; Lock Screen; Swap Pan And Tilt - Chauvet Professional Maverick Storm 1 Wash Schnellanleitung

Pan/Tilt Angle Range

To set the range of motion the pan or tilt is permitted:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Pan Angle or Tilt Angle.
3. Press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select 540 (540° pan), 360 or 270 (360° or 270° for
pan or tilt, respectively) or 180 (180° pan or tilt), or 90 (90° tilt).
5. Press <ENTER>.

Blackout on Pan/Tilt Movement

To set whether the product will black out during pan or tilt movement, follow the instructions below:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select BL. O. P/T Move.
3. Press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (do not black out) or YES (black out
during movement).
5. Press <ENTER>.

Lock Screen

To completely lock or unlock the control panel, follow the instructions below:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Lock Screen.
3. Press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (control panel will not lock) or YES
(control panel will require a passcode to access).
5. Press <ENTER>.
To access the control panel when it has been locked:
1. Press <MENU>.
2. Enter the passcode 0920 with the buttons:
a. Use <DOWN> to select the number to be changed.
b. Use <UP> to increase the value.
c. Repeat until 0920 has been entered.
3. Press <ENTER>.

Swap Pan and Tilt

To switch the pan and tilt functions so that what normally controls the pan controls the tilt and what
normally controls the tilt controls the pan, do the following:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Swap XY.
3. Press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (normal pan and tilt) or YES (pan
controls tilt, tilt controls pan).
5. Press <ENTER>.

WDMX Reset

To reset the WDMX connection from the Maverick Storm 1 Wash and pair it to a WDMX transmitter, do the
following:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select WDMX Reset.
3. Press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (do not reset connection) or YES (reset
the connection).
5. Press <ENTER>.
Once a WDMX receiver has been linked to a specific WDMX transmitter, it will
remain linked to that specific transmitter until it is linked to a different one.
Page 51 of 306
menu.
menu.
menu.
menu.
menu.
Maverick Storm 1 Wash User Manual Rev. 2
Operation