Mounting; Orientation; Rigging - Chauvet Professional Maverick Storm 1 Wash Schnellanleitung

Mounting

Before mounting the product, read and follow the safety recommendations indicated in the
For our CHAUVET Professional line of mounting clamps, go to http://trusst.com/products/.

Orientation

Always mount this product in a safe position and ensure that there is adequate room for ventilation,
configuration, and maintenance. The Maverick Storm 1 Wash can be suspended upright or upside down
using the two Omega brackets included, or it can be placed on it rubber feet on a flat-level surface.

Rigging

Chauvet recommends using the following general guidelines when mounting this product.
• When selecting an installation location, consider easy access to this product for operation,
programming adjustments, and routine maintenance.
• The product is not intended for permanent installation.
• Make sure to mount this product away from any flammable material.
• Never mount in places where rain, high humidity, extreme temperature changes, or restricted
ventilation may affect the product.
• If hanging this product, make sure that the mounting location can support the product's weight. See
the Technical Specifications
• When hanging this product, always secure to a fastening device using a safety cable. For our
CHAUVET Professional line of safety cables, go to http://trusst.com/products/.
• When mounting the product on the floor, make sure that the product and cables are away from
people and vehicles.
• Place the Maverick Storm 1 Wash so that it can move freely without hitting anything or anybody.
• Leave enough slack on the cables to prevent tension and pull on the plugs.
Mounting Diagram
Overhead Mounting
Page 6 of 306
for the weight-bearing requirements of this product.
Mounting clamps
Omega brackets (x2)
Safety cable
Rubber feet (x4)
Floor Mounting
Maverick Storm 1 Wash User Manual Rev. 2
Setup
Safety Notes.