Connecting Up - TAD -C600 Bedienungsanleitung

Connecting up

CAUTION
' Do not turn on the power switch to the TAD-C600 or the other components until all connections have been completed.
' When connecting components or changing connections, always set the power switch to OFF and disconnect the power
cord from its AC outlet. When making connections, connect the power cord last.
' For the DC connection between the power unit and main unit, use only the cords provided with the units, labeled "TAD-C600".
The DC cord furnished with the TAD-D600 CD player cannot be used for this connection.
• Although the power cord to the TAD-C600 is removable, do not attempt to use a power cord other than the
supplied cord.
1. Use the supplied DC cords to connect the main unit to the power unit.
2. Connect other components.
For information on how to connect other components, consult the
operating instructions for the various components you wish to connect.
3. Connect the supplied power cord to the TAD-C600's AC IN connector.
4. Connect the power cord to a standard electrical outlet (U.S. model: AC 120 V;
all other models: AC 220 V to 240 V).
Power unit
Power cord
(supplied)
ON
POWER
OFF
To AC
Power outlet
4
Balanced cables
(commercially available)
2
R
OUTPUT
(BALANCED)
CD player or other audio component
The accompanying illustration depicts the use of balanced cables.
When connecting to input connectors 4, 5, or 6, and output connectors 3, 4, or REC OUT (LINE 6), use commercially available
RCA cables and plugs.
DC cords (supplied)
Main unit
DC2 DC OUTPUT DC1
1
R
AC IN
LINE 1
(BALANCED)
3
L R
OUTPUT
(BALANCED)
Two monaural power amplifiers,
1
DC INPUT
ANALOG OUTPUT REC OUT ANALOG OUTPUT
DC 2
LINE 3 LINE 6
(BALANCED) 2 (BALANCED) 3 4 1 (BALANCED) 2 (BALANCED) 3 4
(BALANCED)
SEE INSTRUCTION MANUAL
DC 1
LINE 2 LINE 3 LINE 4 LINE 5 LINE 6 SLAVE LINE 1 LINE 2 LINE 3
(BALANCED) (BALANCED) IN (BALANCED) (BALANCED) (BALANCED)
ANALOG INPUT
ANALOG INPUT
SIGNAL GND
Balanced
cables
(commercially
available)
L
INPUT INPUT
(BALANCED) (BALANCED)
or stereo power amplifier
When connecting the DC
cable, press the cable's DC
plug into the connector firmly,
then rotate the locking ring to
secure the connection.
1
2
REC OUT
LINE 3 LINE 6
(BALANCED)
L
LINE 4 LINE 5 LINE 6 MASTER
OUT
Balanced
cables
(commercially
available)
R L
INPUT INPUT
(BALANCED) (BALANCED)
Component with analog recording input
* When the analog recording device is
equipped with balanced input connectors,
connect to LINE 3. When using RCA
cables, connect to LINE 6.
TAD-C600
13