Connecting Your Equipment; Connecting To The Pre-Amplifier - TAD -M1000 Bedienungsanleitung

Connecting your equipment

CAUTION
' Do not turn on the power switch to the unit or the other components until all connections have been completed.
' Set the BI-AMP Switch to "Stereo".
We recommend that you place the speakers at the desired location before performing connections. Use commercially
available speaker cables for connections. When connecting other components, make sure to turn the power off and
unplug the other components before connecting.
Speaker

Connecting to the Pre-Amplifier

Using a commercially available cable with balanced-type XLR plug, connect the Pre-Amplifier's balanced output
connectors to this unit's balanced input connectors. When using an unbalanced connection (RCA pin jack), set the
BALANCED/UNBALANCED input connector selector switch to "UNBALANCED".
Note
It is recommended to use less than 3 m length of Cable for connecting input terminal and speaker terminal.
10
INPUT R
BALANCED UNBALANCED
UNBALANCED
BALANCED
SPEAKER R
BI-AMP
STEREO
R
+ -
To speaker
terminal
STEREO
R
R
ANALOG INPUT ANALOG OUTPUT
- +
LINE 1 BALANCED LINE 2 LINE 3 LINE 4 BALANCED
DIGITAL INPUT
D3
D1
USB
D2
XLR COAXIAL
Pre-Amplifier
BALANCED
INPUT L
12 V AUTO
UNBALANCED BALANCED TRIGGER IN POWER DOWN
ON OFF
SPEAKER L
L
- +
AC IN
BI-AMP
To speaker terminal
To balance
output
L
terminal
L
ANALOG INPUT ANALOG OUTPUT
- +
LINE 1 BALANCED LINE 2 LINE 3 LINE 4 BALANCED
12 V TRIGGER
1 2 3
4 5
AC IN
IN OUT
INPUT (BALANCED) terminal
(XLR-3-31 equivalent)
2
3
Speaker
1: Ground
2: Hot
1
3: Cold