TAD -C600 Bedienungsanleitung Seite 10

Power unit
DC2 DC OUTPUT
AC IN
ON
POWER
OFF
1 2
1 Main power switch (POWER ON/OFF)
Use to turn the unit's main power circuits ON/OFF. When the
button's upper half is pressed, the power circuits are turned
ON, and the button on the remote control or the main unit's

front panel can be used to switch the unit between ON and
Standby. When the button's lower half is pressed, the power
circuits are turned OFF.
2 AC IN connector
Attach the accessory power cord here.
3 DC OUTPUT connectors (DC1/DC2)
Use the accessory DC cord to connect the power unit to the
main unit.
4 ANALOG OUTPUT connectors (R/L)
Depending on the type of connectors on your power amplifier,
you can select either balanced (XLR-3-32) or unbalanced (RCA
pin jack) connectors.
5 REC OUT connectors (LINE 3/LINE 6)
Connect to an analog recording device. Set the INPUT
SELECTOR to switch between outputs.
When LINE 3 input is selected, no signal will be output from
LINE 3.
When LINE 6 input is selected, no signal will be output from
LINE 6.
10
Main unit
Balanced output connectors
(equivalent to XLR-3-32)
1 2
3
DC1
R
Balanced input connectors
3
(equivalent to XLR-3-31)
2
1
3
1 : Ground
2 : Hot
4 5
3 : Cold
ANALOG OUTPUT REC OUT
LINE 3 LINE 6
1 2 3 4
(BALANCED) (BALANCED)
(BALANCED)
SEE INSTRUCTION MANUAL
LINE 1 LINE 2 LINE 3 LINE 4 LINE 5 LINE 6 SLAVE
(BALANCED) (BALANCED) (BALANCED) IN
ANALOG INPUT
7 8
1 : Ground
2 : Hot
3 : Cold
6 DC INPUT connectors (DC1/DC2)
Use the accessory DC cord to connect the main unit to the
power unit.
7 ANALOG INPUT connectors (R/L)
In accordance with the type of connector on the device used,
you may select either balanced (XLR-3-31) or unbalanced (RCA
pin jack).
8 SLAVE IN jack
For details, see page 15 "Linking multiple Pre-Amplifiers".
9 SIGNAL GND connector
Use wire material to connect the signal grounds for multiple
components. This is effective for eliminating differences in
polarity between multiple components and thus providing for
greater stability in operation.
Do not connect a safety ground wire to this connector.
10 MASTER OUT jack
For details, see page 15 "Linking multiple Pre-Amplifiers".
6 4 5
DC INPUT
ANALOG OUTPUT REC OUT
DC 2
LINE 3 LINE 6
1 2 3 4
(BALANCED) (BALANCED)
(BALANCED)
DC 1
LINE 1 LINE 2 LINE 3 LINE 4 LINE 5 LINE 6
(BALANCED) (BALANCED) (BALANCED)
ANALOG INPUT
SIGNAL GND
9 7
L
MASTER
OUT
10