Remote Control; Mute Button - TAD -C600 Bedienungsanleitung

Remote control

AMP DISP
1

INPUT
1 2
2
4 5
VOLUME
+
3
–
4
MUTE
TAD-C600
Using the remote control
When using the remote control unit to operate the TAD-C600, point the remote control
at the main unit's remote sensor within the ranges shown in the accompanying
illustration.
' The remote control may not operate properly if obstructions exist between the
remote control unit and the remote sensor, or if the angle between the remote
control and the remote sensor is poor.
' Malfunctions may occur if the TAD-C600 is used nearby other appliances that
emit infrared light, or if remote control units for other devices utilizing infrared light are used nearby. Alternately,
using this remote control unit near other appliances that also utilize infrared light may cause those appliances to
malfunction.
' Replace the batteries when you notice a reduction in the operating range of the remote control unit.
' The remote control may not operate correctly if strong sunlight or light from fluorescent lamps is allowed to strike the
remote sensor directly. In such cases, change the installation location, or remove the fluorescent lamps to a more
distant location.
1 AMP  button
5
Use to switch the main unit's power state between ON and Standby modes.
2 INPUT buttons
3
Use to select to analog inputs.
6
1: Select LINE 1.
2: Select LINE 2.
3: Select LINE 3.
4: Select LINE 4.
5: Select LINE 5.
6: Select LINE 6.
3 VOLUME (+/−) buttons
Press + button to raise sound volume, and – button to lower volume.
4

MUTE button

Press to turn off sound.
5 DISP button
Press to switch amplifier display ON/OFF.
Remote sensor
Remote
30°
control unit
30°
7 m (23 ft.)
TAD-C600
11