Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Select Input Source; Adjust Sound Volume; Changing Settings - TAD -C600 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 36

OPERATION

Select input source

When the INPUT SELECTOR is rotated, the input source changes.
Note
' When power is switched from Standby to ON, the input source automatically switches to the last one used before power
was previously set to Standby.
' When the power plug is disconnected and reconnected, or the main power switch is turned off then on again, the input
source reverts to LINE1 (default value).

Adjust sound volume

Rotate the VOLUME dial to adjust the sound volume. Rotate clockwise to increase sound volume, and counterclockwise to
reduce sound volume. By pressing the FINE button, the volume adjustment mode can be changed as follows:
FINE mode
'
Sound volume is adjusted in increments of 0.5 step.
NORMAL mode
'
Sound volume is adjusted in increments of 1.0 step.

Changing settings

Press the MENU button to change the unit's setting items. Settings 1 to 5 can be selected by pressing the MENU button
the respective number of times. To make a setting, press the +/− button to choose a setting, the press the EXIT button to
confirm the selection.
1.
L-R balance setting
Press the + button to lower the L channel level and shift the sound localization toward the R channel. Press the –
button to lower the R channel level and shift the sound localization toward the L channel. Default value is both L/R
channels set to "0".
2.
Input level setting
This unit allows individual input level settings to be made for different source components, to compensate for
differences in sound volume between high-volume components and low-volume components. Input levels can be set
between –10 dB and +20 dB.
3.
PASS through setting (LINE 2, LINE 5 only)
When an AV amplifier's pre-out output is connected to this unit's LINE 2 or LINE 5 input, the TAD-C600's sound
volume is fixed. When the +/– buttons are pressed, the setting changes as follows:
CAUTION
' When a PASS through setting is assigned to an input connector, the sound volume for that connector can no longer be
adjusted by the TAD-C600. As a result, if the device connected to that connector is not equipped with its own sound-
volume control, a high-level sound volume will be produced, potentially resulting in damage to your speakers. To
prevent such possible damage, connect only a device equipped with its own built-in sound-volume control, and set the
volume control to a low level before connecting.
4.
Auto power-down mode
This setting allows the unit to automatically switch to Standby when not in use. Press the + button to set the mode to
ON (ECO ON), and the – button to set the mode to OFF (ECO OFF). When set to ON, the unit will switch to Standby if
no volume adjustment or key input is made for 3 hours.
14
No setting (default)
PASS through setting: LINE 2
PASS through setting: LINE 5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis