Intended Use; Safety Information - Livarno Living 300181 Gebrauchsanleitung

Congratulations!
With your purchase you have decided on a
high-quality product. Get to know the product
before you start to use it.
Carefully read the following instructions
for use.
Use the product only as described and only
for the given areas of application. Keep these
instructions safe. When passing the product
on to a third party, always make sure that the
documentation is included.
Package contents (Fig. A)
1 x seat (1)
4 x chair legs (2)
1 x connecting element (3)
4 x lock washers (4)
4 x washers (5)
1 x spanner (6)
1 x Allen key (7)
4 x bolts, short (8)
8 x bolts, long (9)
4 x protective caps (10)
4 x nuts (11)
4 x felt pads (12)
1 x instructions
Technical data
Maximum load: 110kg
110
Date of manufacture (month/year):
07/2018
Measurements:
approx. 46 x 53 x 84cm (W x D x H)

Intended use

The item is not intended for commercial use. The
item is designed for indoor use.

Safety information

Life-threatening hazard!
• Never leave children unattended with
the packing materials. There is a risk of
suffocation.
8 GB
Risk of injury!
• Ensure the item is properly stabilised before
using it.
• Place the item on a level surface.
• The item may only be used with adult
supervision, and should not be used as a toy.
• The item may only be used by one person at a
time.
• The item is not a toy or a climbing apparatus!
Ensure that persons, especially children, do
not pull themselves up on the item or lean
against it. The item may fall over.
• Check the item for damage or wear before
each use. Check regularly to make sure that
all bolted connections are tight!
• Do not use the backrest as a seat.
• Never stand on the item.
Assembly
1. Screw all four chair legs (2) to the connecting
element (3) using the long bolts (9) and the nuts
(11). Put on the protective caps (10) (Fig. B).
2. Turn the transport securing device from the
screw threads on the bottom of the seat (1)
(Fig. C).
IMPORTANT! Do not remove the
rubber rings underneath.
3. Put the seat (1) with the bottom side facing
upwards onto a flat and soft surface (Caution:
hard surfaces can scratch the seat!).
4. Bolt the connecting element (3) to the bottom
of the seat (1) using the short bolts (8), the
lock washers (4) and the washers (5) (Fig. D).
IMPORTANT! Align the narrow
spacing of the mounting grommets
on the connecting element facing the
backrest.
IMPORTANT! Only tighten the first
two bolts slightly so as to make it
easier to assemble the chair.
Then tighten all bolts well.
5. Stick a felt pad (12) under each chair leg (2).