Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Congratulations!
You have chosen to purchase a high-quality
product. Familiarise yourself with the product
before using it for the first time.
Read the following assembly
instructions and the safety infor-
mation carefully.
Use the product only as described and only
for the given areas of application. Store these
assembly instructions carefully. When passing
the product on to third parties, please also hand
over all accompanying documents.
Scope of delivery (fig. A)
1 x cover plate (1)
1 x frame, unassembled (2–5)
1 x assembly materials (A–F)
1 x assembly instructions
Technical data
Dimensions: approx. 100 x 72 x 36 cm
(w x h x d)
Maximum load:
25
25 kg
Date of manufacture (month/year):
09/2019
Intended use
The product is designed for use indoors. The
product is not intended for commercial use.
Safety instructions
Danger to life!
• Never leave children unsupervised with the
packaging material. Risk of suffocation.
Risk of injury!
• Before using the product check for correct
stability.
• Position the product on an even surface.
• The product may only be used under adult
supervision and not as a toy.
• The product is not for climbing on or playing
with! Make sure that people, especially chil-
dren, do not pull themselves up on the product
or lean against it. The product may tip over.
• Never stand or sit on the product.
• Make sure that the product is assembled cor-
rectly and in accordance with these assembly
instructions. If assembly is not performed
correctly this can lead to injuries and may also
compromise safety and function.
• Ensure that the wall is suitable for mounting
the product on it. Unsuitable wall surfaces can
lead to injury/damage.
• Check the product for damage and wear be-
fore each use. The product may be used only
when in good working order and condition!
Assembly
To assemble the product you need the Allen key
(F) included in delivery.
1. Place the product on a flat and smooth
surface (Warning: Hard surfaces can lead to
scratches on the product!).
2. Assemble the product as shown in figs. B-E.
Note: Do not tighten the screws too much at
first for easier assembly.
3. Put the product upright on the ground. (fig. F).
Note: Tighten all screws.
4. For optimum stability the product must be
mounted on the wall (fig. E).
Note: For wall assembly use only appropriate
assembly materials (not supplied). Consult your
specialist store if necessary.
Storage, cleaning
When not in use, always store the product clean
and dry at room temperature. Clean only with
water and wipe dry afterwards with a cloth.
IMPORTANT! Never clean the product with
harsh cleaning agents.
GB/MT
13
Werbung
Inhaltsverzeichnis
