Intended Use; Safety Instructions - Livarno Living 333062 1907 Aufbauanleitung

Congratulations!
You have chosen to purchase a high-quality
product. Familiarise yourself with the product
before using it for the first time.
Read the following assembly
instructions and the safety infor-
mation carefully.
Use the product only as described and only
for the given areas of application. Store these
assembly instructions carefully. When passing
the product on to third parties, please also hand
over all accompanying documents.
Scope of delivery (fig. A)
1 x table, unassembled, large (1 - 5)
1 x table, unassembled, small (6 - 10)
12 x screw, short (a)
12 x screw, long (b)
4 x dowel (c)
8 x felt glider pad (d)
1 x Allen key (e)
1 x assembly instructions
Technical data
Dimensions (table, large):
approx. 44 x 50 x 45cm (H x W x D)
Dimensions (table, small):
approx. 36 x 40 x 40cm (H x W x D):
Maximum load: 5kg in each case
Date of manufacture (month/year):
12/2019

Intended use

The product is designed for use indoors. The
product is intended only for private and not for
commercial use.

Safety instructions

Danger to life!
• Never leave children unsupervised with the
packaging material. Risk of suffocation.
Risk of injury!
• Before using the product check for correct
stability.
• Position the product on an even surface.
• The product may only be used under adult
supervision and not as a toy.
• The product is not for climbing on or playing
with! Make sure that people, especially
children, do not pull themselves up on the
product or sit on it. The product may tip over.
• Check the product for damage and wear
before each use. The product may be used
only when in good working order and
condition!
• Make sure that the product is assembled
correctly and in accordance with these
assembly instructions. If assembly is not
performed correctly this can lead to injuries
and may also compromise safety and
function.
• Never stand on the product.
Assembly
You will need a Phillips screwdriver to assemble
the product (not included in delivery).
1. Place each table top (1), (6) on a flat
and soft surface with the drill holes facing
upwards (Warning: Hard surfaces can lead to
scratches on the product!) (fig. B).
2. Use the short screws (a) to attach the frames
(4), (9) to the appropriate table top (fig. B).
3. Use the screws (b) to attach the legs (2), (7) to
the frames (fig. C).
Note: Be sure to align the legs correctly.
4. With the aid of the dowels (c) and the screws
(b), screw the crossbars (5), (10) to the
assembled legs and then tighten all screws
(fig. D).
5. Screw the legs (3), (8) into the crossbars and
the frames (4), (9) (fig. E).
6. Affix the felt glider pads (d) under the legs to
protect the floor against any scratches.
7. Stand the product flat on the ground (fig. F).
GB/IE/NI 7