Niko 10-845 Wichtige Produktinformationen Seite 55

10.13. Loading factory settings
When loading the factory settings, all images are deleted, the master code and all values set by you are reset.
Start the programming
Enter master code
Date set
Invalid value
10.14. Terminating programming
Enter command
Wait
Terminated
11. SETTINGS
11.1. Setting image quality
Line losses in the installation may lead to loss of image quality. To improve the image quality, the video signal on the device can be increased.
Turn the control button clockwise for brightness until there is optimal brightness.
12. CONTROL
12.1. Control in EFH and basic mode
Viewing and deleting stored images
There is no speech connection. The video image is not switched on.
Press the image key on your internal unit. The video image is switched on.
Within 5 sec., press the function key. The most recently stored image appears.
If there are no images available of the serial number in question, the notification No available images appears.
Press this key to go to the next image.
Press the image key to delete the shown image.
If all images have been deleted, the notification No available images appears.
EN
If not already done.
*99 # master code # master code #
Master code = 6-digit number (own master code or factory settings)
A positive confirmation signal sounds. LED lights up yellow during 3 sec. After,
the yellow LED flashes.
If you press #, a negative confirmation tone sounds. The yellow LED flashes
rapidly during 3 sec. and then flashes again.
*9 #
OR
You can not program during 2 min.
A positive confirmation signal sounds. LED lights up yellow during 3 sec.
The yellow LED switches off.
10-845
9 9
9
55