Cleaning And Maintenance - Diamond BC12 Installations-, Bedienungs- Und Artungsanleitung

8. CLEANING AND MAINTENANCE

8.1 Routine maintenance
The routine and preventive maintenance basically consists in the weekly cleaning of the stainless steel parts with lukewarm soapy
water, rinsing abundantly and drying thoroughly. The unit must only be cleaned after first disconnecting the power supply upstream
from the equipment.
Should lime scale form on the bottom of the basin, clean with a vinegar solution or special products before rinsing abundantly with
water and drying.
Warning:
•
Under no circumstances should you use abrasive or corrosive detergents and utensils such as steel wool, brushes or metal
scrapers.
•
Bleach, hydrochloric acid and other compounds containing chlorine will damage the stainless steel.
•
The coloured parts must be cleaned with silicone wax.
•
The floor under the unit must not be washed with corrosive substances that might generate vapours damaging the equipment.
•
During cleaning, do not wash the equipment with jets of water .
8.2 Non-routine maintenance
The non-routine maintenance must be performed by qualified personnel in the event of a fault or anomaly, wherever possible with
the equipment disconnected from the power mains.
In this case, repairs or replacements might be required. The faulty parts must only be replaced with materials and components identical
to the originals or specified by the Manufacturer.
The replacement of components or the modification of the equipment by the user without written permission from the Manufacturer, or
the use of non-authorized spare parts, shall instantly cause the warranty to be void.
8.3 Possible errors
If the BASIN does not heat, check the power supply and make sure the working thermostat is not at the minimum setting.
If the HEATED COMPARTMENT does not heat, check the power supply and make sure the working thermostat is not at the minimum
setting, or that the heated cabinet's vents are obstructed.
If, after performing the checks indicated, correct operation is still not achieved, switch off the equipment and contact the supplier
without delay.
9 SCRAPPING
At the end of its service life, the equipment must be disconnected from the power mains before disassembling the various components.
Special care must be taken to avoid the risk of accidents associated with the form and weight of each component.
The various parts (electrical components, rubber piping, fairlead linings etc.) must be sorted so as to make the best possible
contribution to the protection of the environment in compliance with the laws in force.
TECHNICAL DATA
Compartment type
Overall dimensions mm:
L = length
P = depth
H = height
Depth with tray slide mm
Compartment dimensions mm:
length
depth
height
Compartment capacity – litres
Door type
N° of doors
Number of basins
Basin dimensions mm:
length
depth
height
Basin capacity GN
Water inlet diameter
Water outlet diameter
Basin power kW
Compartment power kW
Total power kW
Supply voltage
Max. weight (Kg).
A010016 Rev. 5
PDF created with FinePrint pdfFactory Pro trial version
Table A:
TECHNICAL FEATURES OF BAIN-MARIE UNITS
BT 8 BT 12 BT 15 BT 23
(EGB 8) (EGB 12) (EGB 15) (EGB 23)
OPEN OPEN OPEN OPEN
800 1200 1500 2300
700 700 700 700
900 900 900 900
1000 1000 1000 1000
520 920 1220 1880
590 590 590 590
400 400 400 400
122 217 287 443
/ / /
/ / /
1 1 1
630 960 1280 1930
510 510 510 510
210 210 210 210
2 1/1 3 1/1 4 1/1 6 1/1
1/2" 1/2" 1/2" 1/2"
1/2" 1/2" 1/2" 1/2"
2.4 3,6 3,6 7,2
/ / /
2,4 3,6 3,6 7,2
380V 380V 380V
230V 1N
3F+N 3F+N 3F+N
70 85 100 135
Pagina 7 di 23
BA 8 BA 12 BA 15
(EAB 8) (EAB 12) (EAB 15)
CABINET CABINET CABINET
800 1200 1500
700 700 700
900 900 900
1000 1000 1000
520 920 1220
590 590 590
400 400 400
122 217 287
/ Hinged Sliding Sliding
/ 1 2 2
1 1 1 1
630 960 1280
510 510 510
210 210 210
2 1/1 3 1/1 4 1/1
1/2" 1/2" 1/2"
1/2" 1/2" 1/2"
2.4 3,6 3,6
/ / / /
2,4 3,6 3,6
380V 380V
230V 1N
3F+N 3F+N
85 108 115
http://www.fineprint.com
BA 23 BC 12 BC 15 BC 23
(EAB 23) (ECB 12) (ECB 15) (ECB 23)
CABINET HEATED HEATED HEATED
2300 1200 1500 2300
700 700 700 700
900 900 900 900
1000 1000 1000 1000
1880 920 1220 1880
590 590 590 590
400 400 400 400
443 217 287 443
Sliding Sliding Sliding Sliding
2 2 2
1 1 1
1930 960 1280 1930
510 510 510 510
210 210 210 210
6 1/1 3 1/1 4 1/1 6 1/1
1/2" 1/2" 1/2" 1/2"
1/2" 1/2" 1/2" 1/2"
7,2 3,6 3,6 7,2
/ 1,6 1,6 2,2
7,2 5,2 5,2 10,4
380V 380V 380V 380V
3F+N 3F+N 3F+N 3F+N
146 110 120 150
GB
2
1