Using Effects; Routing And Effect Settings - Korg KROME EX Blitzstart

Using effects

You have a choice of 193 different digital effects.
The KROME's effect section consists of five insert
effects, two master effects, one total effect, and a mixer
that controls the routing between these effect
processors. Each of these provides stereo input and
output.
You can freely control the effects via dynamic
modulation (Dmod), which lets you use the KROME's
controllers to control the effects in realtime while you
perform, as well as synchronize different types of
modulation effects via the common LFO, or use
MIDI/Tempo Sync to produce tempo-synchronized
effects.

Routing and effect settings

You'll use routing to specify the effects to which the
sound will be sent.
Here's an example of these settings for a song.
1. Select the insert effects that you want to use.
Adjust these settings in the Seq P8: Routing/IFX–
Insert FX Setup page.
2. Specify the effect where the output of each track
will be sent. In the Seq P8: Routing/IFX– Routing
T01–08 page, use "Bus (IFX/Output) Select" to
adjust these settings. For example if you want the
output of track 2 to be the input to insert effect 3,
assign the track 2 "Bus (IFX/Output) Select" to
IFX3.
The upper part of the screen shows the status of the
routing, insert effects, and chain settings. In this
example, T01 (track 1) is assigned to DKit, and uses
IFX1 and 2. This uses the settings of the drum kit. T02
is connected to IFX3, and T04 is chain-connected to
IFX4 and IFX5.
3. "Send1" and "Send2" specify the send levels to
the master effect for each track. "Send1"
corresponds to MFX1, and "Send2" corresponds to
MFX2.
In this page, "Send1" and "Send2" can be selected only
if "Bus (IFX/Output) Select" is set to L/R or Off.
If "Bus (IFX/Output) Select" is set to IFX1–5, the send
levels are specified by "Send1" and "Send2" after the
signal has passed through the insert effects (P8:
Routing/IFX– Insert FX Setup page).
4. Seq P9: MFX/TFX/LFO– Routing page. Here you
can select the master effects and the total effect
that will be used. This page also shows the signal
flow.
Using effects
19
En-